Takashi Matsuzawa(deleted)
|
Re: QNX6.6 BSP cannot work on MCIMX6Q-SDB
|
Takashi Matsuzawa(deleted)
10/22/2015 5:27 AM
post114717
|
Re: QNX6.6 BSP cannot work on MCIMX6Q-SDB
ello, have you resolved this already?
I am also seeing similar issue with SABRE AI (MCIMX6QAICPU1), and it is currently blocking me to go further.
Writing QNX 6.6 BSP image on SD card, booting from SD and it seems that it cause fault? in the middle of boot sequence
and do "Welcome to .." again.
I my case, the console looke like below:
====
Welcome to QNX Neutrino Initial Program Loader for Freescale i.MX6
Quad/Dual/DualLite/Solo/QuadPlus Sabre-ARD RevB (ARM Cortex-A9 MPCore)
i.MX6 Quad or Dual CPU detected.
Command:
Press 'D' for serial download, using the 'sendnto' utility
Press 'M' for SDMMC download, IFS filename MUST be 'QNX-IFS'.
SDMMC download...
sdmmc_highspeed: Switch to high speed mode successful
Load QNX image from SDMMC...
load image done.
Found image @ 0x11800008
Jumping to startup @ 0x1080A690
...
(then, "Welcome to QNX xxxx" and the same lines are printed out)
===
|
|
|