Kevin Stallard(deleted)
|
Re: Installing 6.50 SP1 breaks make (can't find qconfig.mk)
|
Kevin Stallard(deleted)
08/14/2012 4:09 PM
post94822
|
Re: Installing 6.50 SP1 breaks make (can't find qconfig.mk)
So it appears as though the files in the $(QNX_TARGET)/usr/include/mk folder have been removed by the SP1 install.
Anyway to do a QNX i nstall in "repair" mode? Why is SP1 deleting but not updating files?
Thanks
Kevin
|
|
|
Shawn Unger
|
Re: Installing 6.50 SP1 breaks make (can't find qconfig.mk)
|
Shawn Unger
08/21/2012 3:32 PM
post94999
|
Re: Installing 6.50 SP1 breaks make (can't find qconfig.mk)
I discovered the hard way that you MUST include the -E (preserve environment variables) when installing. If not, many,
many files are wiped out.
I.e.
sudo -E ./qnxsdp-6.5.0SP1-20121234567-linux.bin
The only solution after the fact is to completely uninstall 6.5.0* and start over by installing 6.5.0 and then applying
the service pack again.
I hope this helps.
|
|
|
Jeff Pace
|
Re: Installing 6.50 SP1 breaks make (can't find qconfig.mk)
|
Jeff Pace
01/04/2013 6:26 PM
post98394
|
Re: Installing 6.50 SP1 breaks make (can't find qconfig.mk)
Installing on Ubuntu from the DVD seems to break everything. The individual download qnxsdp-6.5.0SP1-201206271006-linux.
bin worked after using the QNXLinuxCleanup and reinstalled 6.5.0.
|
|
|
Ekta Sachdev
|
Re: Installing 6.50 SP1 breaks make (can't find qconfig.mk)
|
Ekta Sachdev
05/27/2015 10:44 AM
post113866
|
Re: Installing 6.50 SP1 breaks make (can't find qconfig.mk)
If you look through the install logs (/opt/qnx650/installLog.txt), double-check whether you're getting an error: "/opt/
qnx650/install/qnxsdp/6.5.0SP1/post_install.sh already exists". I had the same problem, and it all narrowed down to the
'post_install.sh' file already being present, because of previous faulty installation cycles. The installer GUI doesn't
show any errors if the 'post_install.sh' already exists and it seems to install perfectly, but the logs are filled with
errors.
There are two ways to fix it:
(1) Use the cleanup utilities and remove all files associated with SDP6.5.0. Start from scratch and don't miss out on
the sudo -E [if using Ubuntu].
(2) Remove the /opt/qnx650/install/post_install.sh file and /opt/qnx650/install/qnxsdp/6.5.0SP1 directory. If you
install the service pack after that, it should install properly.
Hope this helps
|
|
|