Alan Braddy
|
Re: Loss of debug connectivity
|
Alan Braddy
11/01/2011 5:18 AM
post89788
|
Re: Loss of debug connectivity
Killing and restarting QConn does clear the problem for a few minutes, after which it returns. I can't do this on our
target system though, as it's headless.
(Clarification - I have two systems here, a Kontron development system with keyboard & monitor, and our custom target
system which is only accessible via ethernet. I can swap the (programmed) processor / disk module between the two
systems.)
As far as changes are concerned, I have a number of systems avaialble, my main development board is (as far as I am
aware) unchanged, the others have the same Neutrino build (6.5 generic x86 from the distribution DVD) but may have
slight differences in the configuration files. The new boards are a slightly later hardware build, BIOS version is the
same on all.
All the targets show the same behaviour.
I suspect this may either be something I've inadvertantly changed in a config file, or a side-effect on the development
system of a windows update - but these are just guesses.
|
|
|