Oleg Bolshakov
|
Re: Can´t boot with Fsys.ahci...
|
Oleg Bolshakov
09/20/2013 1:01 PM
post105287
|
Re: Can´t boot with Fsys.ahci...
Hi Victor,
Unfortunately, I don't have Intel DH61WW and Gigabyte GA 277M-D3H (assuming Z77M-D3H). So I have tried to reproduce the
issue on Asus H8H77 mainboard. It is based on H77 chipset that similar to Z77. In my case all works fine. Fsys.atapi
works in IDE mode, Fsys.ahci works without any specific options in AHCI mode.
Can the Gigabyte board set SATA controller to IDE mode? How is it working with Fsys.atapi?
Respectfully,
Oleg
20.09.2013, в 2:34:48, Victor Gamboa написал:
> Hi ! I am installing QNX4 on a CPU ( I tried a Intel DH61WW Chipset Intel and a Gigabyte GA 277M-D3H Chipset Intel)
with Fsys.ahci, but on the Intel Motherboard the boot process stop after 6 dots and in the Gigabyte the computer resets
after the 6 dots of the boot process.
> I did the next: On a Computer where works fine QNX4 I installed a new HD, I installed QNX from Floppy, I Update the
QNX 2.25 version to the 4.25E, I Updated the Networkdrivers, and System Drivers to the last ones that I got on QNX Web
site. I am using this Fsys.ahci file: 85215 Sep 17 18:15 Fsys.ahci, I am using this Proc32 file: 135682 Sep 17 18:15
Proc32. The boot build file has theese lines: $ Proc32 -E0 -l 1 -p 3500 -s 256 -H -f 16 2048 2048, $ Fsys.ahci fsys -M 4
ahci vid=0x8086,did=0x1c02,pci=0. I also tried with $Fsys.ahci alone, but can´t work.
> Please I really appreciate any help or suggestion to install QNX4 on a Computer with Fsys.ahci. Of course on the BIOS
is set the ahci option. Thanks in advance for your help. Victor Gamboa
>
>
>
> _______________________________________________
>
> QNX4 Community Support
> http://community.qnx.com/sf/go/post105261
> To cancel your subscription to this discussion, please e-mail qnx4-community-unsubscribe@community.qnx.com
|
|
|