Hugh Brown
06/18/2012 2:39 PM
post93740
|
Well if cat and echo are working, your serial connection must be good. By
default qtalk doesn't echo characters on your QNX terminal, but if the
serial connection is good, you should at least see the characters on the
other terminal. qtalk is the only emulation program under QNX4, but I'm
sure that there are others in the community if you ask around.
--
Hugh Brown
QNX Software Systems Limited
1001 Farrar Rd.,
Ottawa. ON. K2K 0B3.
Telephone: 613-591-0931
On 12-06-18 1:46 PM, "Will Milner" <community-noreply@qnx.com> wrote:
>I seem to have no connection, but if I use utilities like cat and echo I
>can send and receive but i can't get qtalk to emulate a terminal for me,
>there are no other commands like putty or hyperterminal on qnx that I can
>try? Thanks so much for your help
>
>
>
>_______________________________________________
>
>QNX4 Community Support
>http://community.qnx.com/sf/go/post93738
>To cancel your subscription to this discussion, please e-mail
>qnx4-community-unsubscribe@community.qnx.com
|
|
|
Oleg Bolshakov
06/18/2012 2:57 PM
post93741
|
Hi Will,
To provide remote access to QNX terminal via null-modem cable you should use tinit command.
Respectfully,
Oleg
18.06.2012, в 21:46:57, Will Milner написал(а):
> I seem to have no connection, but if I use utilities like cat and echo I can send and receive but i can't get qtalk to
emulate a terminal for me, there are no other commands like putty or hyperterminal on qnx that I can try? Thanks so
much for your help
>
>
>
> _______________________________________________
>
> QNX4 Community Support
> http://community.qnx.com/sf/go/post93738
> To cancel your subscription to this discussion, please e-mail qnx4-community-unsubscribe@community.qnx.com
|
|
|