Hi everybody,

I am using a convertor by Silicon Labs company for converting RS485 to USB. After some researching, i learned i must run
 devc-serusb in order to create a IO file for my converter, such as /dev/serusb1. My QNX didn't contains devc-serusb 
executable driver file, but i transffered it from Windows to QNX via SSH, put into /sbin directory, applied chmod 
command to run it. Now, i can run devc-serusb but it doesn't create a IO file in dev directory, no /dev/serusbX file. 

The converter is listed by usb (-vvv) command, i see its vid, did, bus, devno etc. When i use commands in http://www.qnx
.com/support/knowledgebase.html?id=50130000000mttO, devc-serusb doesn't run at this time. Obviously, i failed :(

Can you help me about how i can?
Best regards,

Orcun.