Hi,

I have started working on QNX from last week.
I downloaded the latest version of the QNX SDP - 6.5.0 and installed in my windows machine.
I successfully imported the iMx53 BSP to the IDE and was able to build the image filesystem.
After flashing the binary to the target board it worked properly, I was able to enter the ls command and see the 
directories.

I went through the iMx53 BSP source code but I was not able to understand the interrupt handling concept.
Can anyone send a link to document where I can get the information about the interrupt handling in iMx53.

Can anyone explain me how to install/uninstall the device driver.

Is there any driver development kit for the QNX momentics 6.5.0, if so how to install the DDK.

Thanks & Regards
Kishore.S


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.