I would like to use QNX on a Gumstix-Duovero board, with an OMAP4430 microprocessor. I've found a BSP for this processor
, but it was written for the PandaBoard, which doesn't have the same muxing/devices. So far I've managed to launch U-
Boot and to execute the startup code of the QNX image, but the kernel crashes just when the process "procnto" is 
launched.

I suspect that it might be an issue with the memory (RAM memory is not the same), or with the interrupt lines. Do you 
have any suggestions about what I should modify on the BSP? Do you think that it is necessary to modify any callouts? 

Thank you in advance