> Hi,
> 
> This mail with reference to porting QNX on freescale p1025 twr-module. when I 
> Power ON p1025 twr-module, I could assign IP addr and server IP from 
> hyperterminal for p1025 target board IP and host IP with help of uboot command
>  and I could map qnx build image file also(ie, ifs-p1025twr.raw), but when I 
> boot image file It shows un-read able characters. I  have attached output snap
>  shots for your reference...
> 
> We set the value of baud rate in terminal as per standard ---    115200
> u-boot version  --- UBOOT (2011.09) (p1025 TWR module).
> Serial driver starting in startup script --- devc-ser8250 –e –c384000000 –
> b115200 0xffe04500,16
> 
> The freescale TWR module by default comes with U boot, we just porting QNX 
> build image on top of that. If we change build file as per Qnx document for 
> solving this issue will not be affect after building. The TWR module what we 
> have does not have serial port, we tried to porting using by OTG USB port..
> what my understanding is what we have twr module does not have RS232 serial 
> port, but we are using for qnx image porting by USB OTG port. so that when Qnx
>  image start it will looks serial terminal driver execution which is not 
> present in TWR module. Is this issue getting this junk characters when its 
> start execution serial driver...?   
> 
> Best regards,
> 
> Jagan N 
>                                 

You need to post in BSP forum if you want anyone to see it.

http://community.qnx.com/sf/discussion/do/listTopics/projects.bsp/discussion.bsp